Users Guide

34
Multicast
The multicast commands are supported by Dell Networking operating system (OS) on all S3048–ON platform.
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information
base, use the clear ip pim tib command.
Syntax
clear ip mroute [vrf vrf-name] {group-address [source-address] | * |
snooping}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to
congure this setting on that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
group-address
[source-address]
Enter the multicast group address and source address (if desired), in dotted
decimal format, to clear information on a specic group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping route table entries.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Added support for keyword snooping on the Z9000, S4810, and S4820T.
9.0.2.0 Introduced on the S6000.
986
Multicast