Users Guide
protocol spanning-tree mstp
To enable and congure the multiple spanning tree group, enter MULTIPLE SPANNING TREE mode.
Syntax
protocol spanning-tree mstp
To disable the multiple spanning tree group, use the no protocol spanning-tree mstp command.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage Information
MSTP is not enabled when you enter MULTIPLE SPANNING TREE mode. To enable MSTP globally on the
switch, enter the no disable command while in MULTIPLE SPANNING TREE mode.
For more information about the multiple spanning tree protocol, refer to the Dell Networking OS
Conguration Guide.
Example
Dell(conf)#protocol spanning-tree mstp
Dell(config-mstp)#no disable
Related Commands disable — disables multiple spanning tree.
Multiple Spanning Tree Protocol (MSTP)
977