Users Guide
ip msdp sa-lter
Permit or deny MSDP source active (SA) messages based on multicast source and/or group from the specied peer.
Syntax
ip msdp sa-filter {in | out} peer-address list [access-list name]
Remove this conguration using the no ip msdp sa-filter {in | out} peer address list
[access-list name] command.
Parameters
in Enter the keyword in to enable incoming SA ltering.
out Enter the keyword out to enable outgoing SA ltering.
peer-address Enter the peer address of the MSDP peer in a dotted decimal format (A.B.C.D.).
access-list name Enter the name of an extended ACL that contains permitted SAs. If you do not use
this option, all local entries are blocked.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the E-Series.
ip msdp sa-limit
Congure the upper limit of source-active (SA) entries in SA-cache.
Syntax
ip msdp sa-limit number
964
Multicast Source Discovery Protocol (MSDP)