Users Guide
ip msdp mesh-group
To be a member of a mesh group, congure a peer.
Syntax
ip msdp mesh-group {name} {peer address}
To remove the peer from a mesh group, use the no ip msdp mesh-group {name} {peer
address} command.
Parameters
name Enter a string of up to 16 characters long for as the mesh group name.
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.2.1.1 Introduced
Usage Information An MSDP mesh group is a mechanism for reducing SA ooding, typically in an intra-domain setting. When
some subset of a domain’s MSDP speakers are fully meshed, they can be congured into a mesh-group. If
member X of a mesh-group receives a SA message from an MSDP peer that is also a member of the mesh-
group, member X accepts the SA message and forwards it to all of its peers that are not part of the mesh-
group. However, member X cannot forward the SA message to other members of the mesh-group.
ip msdp originator-id
Congure the MSDP Originator ID.
Syntax
ip msdp originator-id {interface}
960
Multicast Source Discovery Protocol (MSDP)