Users Guide
Version Description
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
protocol lldp (Interface)
Enter the LLDP protocol in INTERFACE mode.
Syntax
[no] protocol lldp
To return to the global LLDP conguration mode, use the no protocol lldp command from Interface
mode.
Defaults LLDP is not enabled on the interface.
Command Modes INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
Before LLDP can be congured on an interface, it must be enabled globally from CONFIGURATION mode.
This command places you in LLDP mode on the interface; it does not enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global congurations. When you
execute the no protocol lldp from INTERFACE mode, interfaces begin to inherit the conguration
from global LLDP CONFIGURATION mode.
938
Link Layer Discovery Protocol (LLDP)