Users Guide
packet (OPTIONAL) Enter the keyword packet to display information regarding packets
coming in or going out.
brief (OPTIONAL) Enter the keyword brief to display brief packet information.
detail (OPTIONAL) Enter the keyword detail to display detailed packet information.
tx (OPTIONAL) Enter the keyword tx to display transmit-only packet information.
rx (OPTIONAL) Enter the keyword rx to display receive-only packet information.
both (OPTIONAL) Enter the keyword both to display both receive and transmit packet
information.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
disable
Enable or disable LLDP.
Syntax
disable
To enable LLDP, use the no disable command.
Defaults Enabled, that is no disable.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Link Layer Discovery Protocol (LLDP)
933