Users Guide

Version Description
pre-6.2.1.1 Introduced on the E-Series.
Usage Information
When this command is congured, the VLAN is operationally UP if any of the interfaces specied in the
track ip command are operationally UP, and the VLAN is operationally DOWN if none of the tracking
interfaces are operationally UP.
If the track ip command is not congured, the VLAN's Layer 3 operational state depends on all the
members of the VLAN.
The Layer 2 state of the VLAN, and hence the Layer 2 trac, is not aected by the track ip command
conguration.
Related Commands
interface vlan — congures a VLAN.
tagged — species which interfaces in a VLAN are tagged.
untagged
Add a Layer 2 interface to a VLAN as an untagged interface.
Syntax
untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a port channel interface, enter the keywords port-channel then a
number.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults All interfaces in Layer 2 mode are untagged.
Command Modes INTERFACE VLAN
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
Layer 2
917