Users Guide
route-map map-
name
map-name is an identier for a congured route map. The route map should lter
imported routes from the source routing protocol to the current routing protocol.
If you do not specify a map-name, all routes are redistributed. If you specify a
keyword, but fail to list route map tags, no routes are imported.
Defaults Refer to Parameters.
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Added support for IPv6 ISIS.
6.3.1.0 Introduced.
Usage Information How a metric value assigned to a redistributed route is advertised depends on how on the conguration of
the metric-style command. If the metric-style command is set for Narrow mode and the metric
value in the redistribute ospf command is set to a number higher than 63, the metric value
advertised in LSPs is 63. If the
metric-style command is set for wide mode, the metric value in the
redistribute ospf command is advertised.
router isis
Allows you to enable the IS-IS routing protocol and to specify an IP IS-IS process.
Syntax
router isis [vrf vrf-name] [tag]
To disable IS-IS routing, use the no router isis [tag] command.
868
Intermediate System to Intermediate System (IS-IS)