Users Guide
Dell(conf)#ipv6 route vrf vrf_test 44::/64 33::1 weight 100
Dell(conf)#ipv6 route vrf vrf_test 44::/64 33::2 weight 200
Dell(conf)#do show running-config | grep ipv6 route vrf
Related Commands show ipv6 route — views the IPv6 congured routes.
ipv6 unicast-routing
Enable IPv6 unicast routing on the device.
Syntax
ipv6 unicast-routing
To disable unicast routing, use the no ipv6 unicast-routing command.
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information Because this command is enabled by default, it does not appear in the running conguration. When you
disable unicast routing, the no ipv6 unicast-routing command is included in the running
conguration. Whenever unicast routing is disabled or re-enabled, Dell Networking OS generates a syslog
message indicating the action.
Disabling unicast routing on an E-Series chassis causes the following behavior:
• static and protocol learned routes are removed from RTM and from the CAM; packet forwarding to
these routes is terminated
• connected routes and resolved neighbors remain in the CAM and new IPv6 neighbors are still
discoverable
• additional protocol adjacencies (OSPFv3 and BGP4) are brought down and no new adjacencies are
formed
IPv6 Basics
807