Users Guide

no-advertise Enter the keyword no-advertise to prevent the specied prex from being
advertised.
no-autocong Enter the keywords no-autoconfig to disable Stateless Address
Autoconguration.
no-rtr-address Enter the keyword no-rtr-address to exclude the full router address from
router advertisements (the R bit is not set).
o-link Enter the keywords off-link to advertise the prex without stating to recipients
that the prex is either on-link or o-link.
valid-lifetime |
innite
Enter the amount of time that the prex is advertised, or enter infinite for an
unlimited amount of time. The range is from 0 to 4294967295. The default is
2592000. The maximum value means that the preferred lifetime does not expire
for the valid-life time parameter.
preferred-lifetime |
innite
Enter the amount of time that the prex is preferred, or enter infinite for an
unlimited amount of time. The range is from 0 to 4294967295. The default is
604800. The maximum value means that the preferred lifetime and does not
expire.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series TeraScale, C-Series, and S-Series.
Usage Information By default, all prexes congured as addresses on the interface are advertised. This command allows control
over the individual parameters per prex; you can use the default keyword to use the default parameters
for all prexes. If a prex has been congured with lifetime parameter values, the default values cannot be
applied using the ipv6 nd prefix default no-autoconfig command.
804
IPv6 Basics