Users Guide
Version Description
8.3.7.0 Introduced on the S4810.
ipv6 owlabel-zero
Congure system to set the ow label eld in the packets to zero.
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the eld and allow the protocol operations to ll the eld, use the no
ipv6 flowlabel-zero command.
Default Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information If the owlabel value is already set for BGP or SSH, the system defaults to the already congured value. All
packets on the same connection are considered part of the same ow by the system. For new connections,
set the new owlabel to zero.
ipv6 host
Assign a name and IPv6 address the host-to-IPv6 address mapping table uses.
Syntax
ipv6 host name ipv6-address
To remove an IP host, use the no ipv6 host name {ipv6–address}.
Parameters
name Enter a text string to associate with one IP address.
800
IPv6 Basics