Users Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Introduced.
Usage Information This command allows you to create an EUI64 address based on the specied prex and MAC address only.
Prexes may be congured on the interface using the ipv6 nd prefix command without creating an
EUI64 address.
Example
Dell(conf)#int gig 1/4
Dell(conf-if-gi-1/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int gig 1/6
Dell(conf-if-gi-1/6)#ipv6 address 801:10::/64 eui64
ipv6 control-plane icmp error-rate-limit
Congure the maximum number of ICMP error packets per second that can be sent per second.
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-rate-limit
command.
Parameters
pps Enter the maximum number of error packets generated per second. The range is
from 1 to 200, where 0 disables the rate-limiting.
Default 100 pps
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
IPv6 Basics
799