Users Guide

Version Description
9.4(0.0) Added support for CoPP for OSPFv3 on the S4810, S4820T, S6000, and Z9000
platforms.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000
8.3.11.1 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series. Increased the name string to accept up to 140
characters. Prior to version 7.8.1.0, names are up to 16 characters long.
7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed specication on entries allowed
per ACL, refer to your line card documentation. You can create an IPv6 ACL for control-plane trac policing
for OSPFv3, in addition to the CoPP support for VRRP, BGP, and ICMP.
cam-acl-egress
Allocate space for IPv6 egress ACLs.
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default Use the default CAM prole settings, and set the CAM as follows:
• L2 ACL(l2acl): 1
• L3 ACL (ipv4acl: 1
• IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4 ipv4acl 1- 4
ipv6acl 0-4
Allocate space to support IPv6 ACLs. Enter all of the proles and a range. Enter the
CAM prole name then the amount to be allotted. The total space allocated must
equal 4. The ipv6acl range must be a factor of 2.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
790
IPv6 Access Control Lists (IPv6 ACLs)