Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON
781782783784785786787788789790
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
ipv6 access-list
Congure an access list based on IPv6 addresses or protocols.
Syntax
ipv6 access-list access-list-name cpu-qos
To delete an access list, use the no ipv6 access-list access-list-name command.
Parameters
access-list-name Enter the access list name as a string, up to 140 characters.
cpu-qos Enter the keyword cpu-qos to assign this ACL to control plane trac only
(CoPP).
permit Enter the keyword permit to congure a lter to forward packets meeting this
condition.
deny Enter the keyword deny to congure a lter to drop packets meeting this
condition.
ospfv3 Specify that this ACL is for OSPFv3 control plane trac
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet is dropped.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
IPv6 Access Control Lists (IPv6 ACLs)
789