Users Guide

25
IPv6 Access Control Lists (IPv6 ACLs)
IPv6 ACLs and IPv6 Route Map commands are supported on Dell Networking OS.
NOTE: For IPv4 ACL commands, refer to the Access Control Lists (ACL) chapter.
Important Points to Remember
• Certain platforms require manual CAM usage space allotment. For more information, refer to the cam-acl command.
• Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.
• Reference to an empty ACL permits any trac.
• ACLs are not applied to self-originated trac (for example, Control Protocol trac not aected by IPv6 ACL because the routed
bit is not set for Control Protocol trac and for egress ACLs the routed bit must be set).
• You can use the same access list name for both IPv4 and IPv6 ACLs.
• You can apply both IPv4 and IPv6 ACLs on an interface at the same time.
• You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).
• Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.
• Because the prex mask is specied in /x format in IPv6 ACLs, inverse mask is not supported.
show cam-acl-egress
Show information on FP groups allocated for egress ACLs.
Syntax
show cam-acl-egress
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
784
IPv6 Access Control Lists (IPv6 ACLs)