Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information To congure a list of possible domain names, congure the ip domain-list command up to six times.
If you congure both the ip domain-name and ip domain-list commands, the software tries to
resolve the name using the
ip domain-name command. If the name is not resolved, the software goes
through the list of names congured with the ip domain-list command to nd a match.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view a DNS-related conguration, use the
show running-config resolve command.
Related Commands ip domain-name — species a DNS server.
ip domain-lookup
To address resolution (that is, DNS), enable dynamic host-name.
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
IPv4 Routing
735