Users Guide
Version Description
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage Information
Use the vrf vrf-name attribute of this command to clear routes corresponding to either a specic VRF
or the default VRF.
You cannot use this attribute to clear routes corresponding to a management VRF.
Related Commands
ip route — assigns an IP route to the switch.
show ip route — views the routing table.
show ip route summary — views a summary of the routing table.
clear tcp statistics
Clear TCP counters.
Syntax
clear tcp statistics [all | cp]
Parameters
all Enter the keyword all to clear all TCP statistics maintained on all switch
processors.
cp (OPTIONAL) Enter the cp to clear only statistics from the Control Processor.
rp (OPTIONAL) Enter the keyword rp to clear only the statistics from Route
Processor.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
IPv4 Routing
725