Users Guide
ip ip-address (OPTIONAL) Enter the keyword ip then the IP address of the ARP entry you wish
to clear.
no-refresh (OPTIONAL) Enter the keywords no-refresh to delete the ARP entry from
CAM. Or use this option with interface or ip ip-address to specify which
dynamic ARP entries you want to delete.
NOTE: Transit trac may not be forwarded during the period when deleted
ARP entries are resolved again and re-installed in CAM. Use this option
with extreme caution.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the prior limit was
2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
clear host
Remove one or all dynamically learned host table entries.
Syntax
clear host name
722
IPv4 Routing