Users Guide

• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
• null — Causes an encryption policy congured for the area to not be inherited
on the interface.
esp-authentication Enter the keywords esp-authentication then the transform type of
operation to apply to trac. The transform type represents the encryption or
authentication applied to trac.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
• null — Causes an encryption policy congured for the area to not be inherited
on the interface.
esp-encryption Enter the keywords esp-encryption then the transform type of operation to
apply to trac. The transform type represents the encryption or authentication
applied to trac.
• 3des — Use 3DES encryption.
• cbc — Use CDC encryption.
• des — Use DES encryption.
• null — Causes an encryption policy congured for the area to not be inherited
on the interface.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.2(1.0) Introduced on the Z9500.
Usage Information
• Both sides of the link must specify the same transform set.
• You can create up to 64 transform sets.
Example
Dell(conf)#do show crypto ipsec transform-set
Transform-Set Name : ts1
Transform-Set refCnt : 0
AH Transform : md5
ESP Auth Transform :
ESP Encry Transform :
Dell(conf)#
Internet Protocol Security (IPSec)
709