Users Guide

Input 44506754 IP Packets, 0 Vlans 0 MPLS
41 64-byte pkts, 44502871 over 64-byte pkts, 249 over 127-byte pkts
407 over 255-byte pkts, 3127 over 511-byte pkts, 606 over 1023-byte pkts
Received 0 input symbol errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 IP Checksum, 0 overrun, 0 discarded
1218120 packets output, 100745130 bytes, 0 underruns
Output 5428 Multicasts, 4 Broadcasts, 1212688 Unicasts
1216142 IP Packets, 0 Vlans, 0 MPLS
0 throttles, 0 discarded
Rate info (interval 299 sec):
Input 01.50Mbits/sec, 2433 packets/sec
Output 00.02Mbits/sec,4 packets/sec
Time since last interface status change: 00:22:34
Dell#
User Information The following describes the show interfaces port-channel brief command shown in the
following example.
Field Description
LAG Lists the port channel number.
Mode Lists the mode:
• L3 — for Layer 3
• L2 — for Layer 2
Status Displays the status of the port channel.
• down — if the port channel is disabled (shutdown)
• up — if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
• In Layer 2 port channels, an * (asterisk) indicates which interface is the primary
port of the port channel. The primary port sends out interface PDU.
• In Layer 3 port channels, the primary port is not indicated.
Example
Dell#show interfaces port-channel 1 brief
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Gi 3/1 (Up) *
Gi 3/2 (Down)
Gi 3/3 (Up)
Dell#
Related Commands
show lacp — displays the LACP matrix.
700
Interfaces