Users Guide

management egress-interface-selection
To make congured application trac egress through the management port instead of the front-end (FE) port, enable and congure
a management egress interface.
Syntax
management egress-interface-selection
To disable and remove management egress interface selection (EIS) congurations, use the no
management egress-interface-selection command.
Defaults None.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
show ip management-eis-route
Display the management routes used by EIS.
Syntax
show ip management-eis-route
Defaults None.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
Example
Dell#show ip management-eis-route
Destination Gateway State Route Source
----------- ------- ----- ------------
Interfaces
689