Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example
Dell(conf)#interface range gigabitethernet 1/1 - 1/2
Dell(conf-if-range-gi-1/1-2)#show config
!
interface GigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface GigabitEthernet 1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-gi-1/1-1/2)#
show interfaces
Display information on a specic physical interface or virtual interface.
Syntax
show interfaces interface-type slot/port/
Parameters
interface Enter one of the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For stack-units, enter the keywords stack-unit then the slot/port
information.
•
For a Null interface, enter the keyword null then the Null interface number.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter gigabitethernet slot/port.
• For a 1-Gigabit Ethernet interface, enter gigabitethernet slot/port.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
658
Interfaces