Users Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale. Prior releases supported
2094.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.1.1.0 Introduced on the E-Series.
Example (Single
Range)
This example shows how to dene an interface range macro named test. Execute the show running-
config command to display the macro denition.
Dell(config)# define interface-range test gigabitethernet 1/1 - 1/3,
gigabitethernet 5/1 - 5/47, gigabitethernet 3/1 - 3/8
Dell# show running-config | grep define
define interface-range test gigabitethernet 1/1 - 1/3, gigabitethernet 5/1
- 5/47,
gigabitethernet 3/1 - 3/8
Dell(config)#interface range macro test
Dell(config-if-range-gi-1/1-1/3,te-5/1-5/47,te-3/1-3/8)#
Related Commands
interface range – congures a range of command (bulk conguration)
interface range macro name – runs an interface range macro.
interface range macro name
Run the interface-range macro to automatically congure the pre-dened range of interfaces.
Syntax
interface range macro name
Parameters
name Enter the name of an existing macro.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Interfaces
645