Users Guide
required between the commas. The ranges can include VLANs, port-channels, and
physical interfaces.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a Tunnel interface, enter the keyword Tunnel then a number from 1 to
16383.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P2) Introduced on the S4038-ON.
9.8(0.0P5) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale. Prior releases supported
2094.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information When creating an interface range, interfaces appear in the order they are entered; they are not sorted. The
command veries that interfaces are present (physical) or congured (logical).
Important Points to Remember:
• Bulk conguration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk conguration with a warning message.
642
Interfaces