Users Guide

on on on on
on on on on
Related Commands
• show running-cong — display the ow conguration parameters (non-default values only).
• show interfaces — display the negotiated ow control parameters.
interface
Congure a physical interface on the switch.
Syntax
interface interface range
Parameters
interface Enter one of the following keywords and slot/port or number information:
• For a null interface, enter the keyword null then the slot/port information.
The Null interface number is 0.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
range (Optional) Enter the keyword range to congure an interface range.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added the support for interfaces.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
636
Interfaces