Users Guide

Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell#clear dampening gigabitethernet 1/10
Clear dampening counters on TeGi 1/10 [confirm] y
Dell#
Related Commands
show interfaces dampening — displays interface dampening information.
dampening — congures dampening on an interface.
dampening
Congure dampening on an interface.
Syntax
dampening [[[[half-life] [reuse-threshold]] [suppress-threshold]] [max-
suppress-time]]
Parameters
half-life Enter the number of seconds after which the penalty is decreased. The penalty
decreases half after the half-life period expires. The range is from 1 to 30 seconds.
The default is 5 seconds.
reuse-threshold Enter a number as the reuse threshold, the penalty value below which the interface
state is changed to “up”. The range is from 1 to 20000. The default is 750.
suppress-threshold Enter a number as the suppress threshold, the penalty value above which the
interface state is changed to “error disabled”. The range is from 1 to 20000. The
default is 2500.
max-suppress-time Enter the maximum number for which a route can be suppressed. The default is
four times the half-life value. The range is from 1 to 86400. The default is 20
seconds.
Defaults Disabled.
Command Modes INTERFACE (conf-if-)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
Interfaces
629