Users Guide
ip igmp ssm-map
To translate (*,G) memberships to (S,G) memberships, use a statically congured list.
Syntax
ip igmp [vrf vrf-name] ssm-map std-access-list source-address
Undo this conguration, that is, remove SSM map (S,G) states and replace them with (*,G) state, use the
ip igmp [vrf vrf-name] ssm-map std-access-list source-address command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to
congure this setting on that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
std-access-list Specify the standard IP access list that contains the mapping rules for multicast
groups.
source-address Specify the multicast source address to which the groups are mapped.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.7.1.0 Introduced on the E-Series.
Usage Information Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reected in the IGMP groups.
You may not use extended access lists with this command. When you congure a static SSM map and the
router cannot nd any matching access lists, the router continues to accept (*,G) groups.
Related Commands ip access-list standard — creates a standard access list to lter based on IP address.
Internet Group Management Protocol (IGMP)
609