Users Guide

Field Description
RPM Redundancy
Conguration
Displays the following information:
• which RPM is the preferred Primary on next boot (the redundancy
primary command)
• the data sync method congured (the redundancy synchronize
command)
• the failover type (you cannot change this type; it is software-dependent). Hot
Failover means that the running conguration and routing table are applied on
secondary RPM. Fast Failover means that the running conguration is not
applied on the secondary RPM until failover occurs, and the routing table on
line cards is cleared during failover.
• the status of auto booting the RPM (the redundancy disable-auto-
reboot command)
• the parameter for auto failover limit control (the redundancy auto-
failover-limit command)
•
RPM Failover
Record
Displays the following information:
• RPM failover counter (to reset the counter, use the redundancy reset-
counter command)
• the time and date of the last RPM failover
• the reason for the last RPM failover
Last Data Sync
Record
Displays the data sync information and the timestamp for the data sync:
• Start-up Cong is the contents of the startup-cong le.
• Line Card Cong is the line card types congured and interfaces on those line
cards.
• Runtime Event Log is the contents of the Event log.
• Running Cong is the current running-cong.
This eld only appears when you enter the command from the Primary RPM.
Example
Dell#show redundancy
-- RPM Status --
------------------------------------------------
RPM Slot ID: 1
RPM Redundancy Role: Primary
RPM State: Active
RPM SW Version: 7.5.1.0
Link to Peer: Up
-- PEER RPM Status --
------------------------------------------------
RPM State: Standby
RPM SW Version: 7.5.1.0
-- RPM Redundancy Configuration --
------------------------------------------------
Primary RPM: rpm0
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot RPM: Enabled
Auto failover limit: 3 times in 60 minutes
598
High Availability (HA)