Users Guide

rpm1 Enter the keyword rpm1 to set the RPM in slot R1 as the primary RPM.

Default The RPM in slot R0 is the Primary RPM.

Command Modes CONFIGURATION

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.5.1.0 Introduced on the C-Series.

7.6.1.0 Introduced on the E-Series.

redundancy protocol

Enable hitless protocols.

Syntax

redundancy protocol {lacp | xstp}

To disable a hitless protocol, use the no redundancy protocol {lacp | xstp} command.

Parameters

lacp Enter the keyword lacp to make LACP hitless.

xstp Enter the keyword xstp to invoke hitless STP (all STP modes — MSTP, PVST+,

RSTP, and STP).

Default Disabled