Users Guide
Parameters
xed Enter the keyword fixed then the VLAN range in a comma-separated VLAN ID
set.
normal Enter the keyword normal then the VLAN range in a comma-separated VLAN ID
set. This setting is the default.
forbidden Enter the keyword forbidden then the VLAN range in a comma-separated
VLAN ID set.
Defaults normal
Command Modes CONFIGURATION-INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Usage Information
Fixed registration prevents an interface, congured using the command line, to belong to a VLAN (static
conguration) from being uncongured when it receives a Leave message. Therefore, Registration mode
on that interface is xed.
Normal registration is the default registration. The port’s membership in the VLAN depends on GVRP. The
interface becomes a member of a VLAN after learning about the VLAN through GVRP. If the VLAN is
removed from the port that sends GVRP advertisements to this device, the port stops being a member of
the VLAN.
To advertise or learn about VLANs through GVRP, use the forbidden command when you do not want
the interface.
Related Commands show gvrp — displays the GVRP conguration including the registration.
GARP VLAN Registration (GVRP)
581