Users Guide
disable
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults Enabled.
Command Modes CONFIGURATION-GVRP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Related Commands
gvrp enable — enables GVRP on physical interfaces and LAGs.
protocol gvrp — access GVRP protocol.
garp timers
Set the intervals (in milliseconds) for sending GARP messages.
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave | leave-all}
command.
578
GARP VLAN Registration (GVRP)