Users Guide

2 Up Master 2 11-20, 25, 27-30
Dell#
Related Commands protocol frrp — enters the resilient ring protocol and designate a ring identication.
timer
Set the hello interval or dead interval for the Ring control packets.
Syntax
timer {hello-interval milliseconds}| {dead-interval milliseconds}
To remove the timer, use the no timer {hello-interval [milliseconds]}| {dead-
interval milliseconds} command.
Parameters
hello-interval
milliseconds
Enter the keyword hello-interval then the time, in milliseconds, to set the
hello interval of the control packets. The milliseconds must be entered in
increments of 50 millisecond; for example, 50, 100, 150, and so on. If an invalid
value is entered, an error message is generated. The range is from 50 to 2000 ms.
Default: 500 ms.
dead-interval
milliseconds
Enter the keyword dead-interval then the time, in milliseconds, to set the
dead interval of the control packets. The range is from 50 to 6000 ms. Default:
1500 ms.
NOTE: The congured dead interval must be at least three times the hello
interval.
Defaults
• 500 ms for hello-interval milliseconds
• 1500 ms for dead-intervalmilliseconds
Command Modes CONFIGURATION (conf-frrp)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Force10 Resilient Ring Protocol (FRRP)
573