Users Guide

To enter OPENFLOW INSTANCE mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the openflow of-instance command then the OpenFlow ID number of the instance you want to create or

congure. The prompt changes to include (conf-of-instance

of-id).

You can return to the CONFIGURATION mode by entering the exit command.

Per-VLAN SPANNING TREE (PVST+) Plus Mode

To enable and congure the Per-VLAN Spanning Tree (PVST+) protocol, use PVST+ mode. For more information, refer to Per-VLAN

Spanning Tree Plus (PVST+).

NOTE: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.

To enter PVST+ mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the protocol spanning-tree pvst command. The prompt changes to include (conf-pvst).

You can return to CONFIGURATION mode by using the exit command.

PORT-CHANNEL FAILOVER-GROUP Mode

To congure shared LAG state tracking, use PORT-CHANNEL FAILOVER-GROUP mode. For more information, refer to Port

Channel Commands.

To enter PORT-CHANNEL FAILOVER-GROUP mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the port-channel failover-group command. The prompt changes to include (conf-po-failover-grp).

You can return to CONFIGURATION mode by using the exit command.

PREFIX-LIST Mode

To congure a prex list, use PREFIX-LIST mode.

To enter PREFIX-LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the ip prefix-list command. Include a name for the prex list. The prompt changes to include (conf-nprexl).

You can return to CONFIGURATION mode by using the exit command.

PROTOCOL GVRP Mode

To enable and congure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For more information, refer to

GARP VLAN Registration (GVRP).

To enter PROTOCOL GVRP mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the protocol gvrp command. The prompt changes to include (cong-gvrp).

You can return to CONFIGURATION mode by using the exit command.

RAPID SPANNING TREE (RSTP) Mode

To enable and congure RSTP, use RSTP mode. For more information, refer to Rapid Spanning Tree Protocol (RSTP).

To enter RSTP mode:

CLI Basics