Users Guide

14
Dynamic Host Conguration Protocol (DHCP)
Dynamic host conguration protocol (DHCP) is an application layer protocol that dynamically assigns IP addresses and other
conguration parameters to network end-stations (hosts) based on the conguration policies the network administrators determine.
Commands to Congure the System to be a DHCP Server
To congure the system to be a DHCP server, use the following commands.
clear ip dhcp
Reset the DHCP counters.
Syntax
clear ip dhcp [binding {address} | conflict | server statistics]
Parameters
binding Enter the keyword binding to delete all entries in the binding table.
address Enter the IP address to clear the binding entry for a single IP address.
conicts Enter the keyword conflicts to delete all of the log entries created for IP
address conicts.
server statistics Enter the keywords server statistics to clear all the server counter
information.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
512
Dynamic Host Conguration Protocol (DHCP)