Users Guide

Prompt Interface Type
Dell(conf-if)#
INTERFACE mode
Dell(conf-if-
gi-1/1)#
Gigabit Ethernet interface then the slot/port information
Dell(conf-if-
te-1/1)#
Ten-Gigabit Ethernet interface then slot/port information
Dell(conf-if-
lo-0)#
Loopback interface number
Dell(conf-if-
nu-0)#
Null Interface then zero
Dell(conf-if-
po-0)#
Port-channel interface number
Dell(conf-if-
vl-0)#
VLAN Interface then VLAN number (range 1–4094)
Dell(conf-if-
ma-1/1)#
Management Ethernet interface then slot/port information
Dell(conf-if-
tu-0)#
Tunnel interface then tunnel ID.
Dell(conf-if-
range)#
Designated interface range (used for bulk conguration).
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and congure either standard or extended access control lists (ACLs), use the ip access-list
standard
or ip access-list extended command.
To enter IP ACCESS LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the ip access-list standard or ip access-list extended command. Include a name for the ACL. The
prompt changes to include (conf-std-nacl) or (conf-ext-nacl).
You can return to CONFIGURATION mode by using the exit command.
ISIS ADDRESS-FAMILY Mode
To enable or congure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, refer to Intermediate System to
Intermediate System (IS-IS).
To enter ISIS ADDRESS-FAMILY mode:
1. Verify that you are logged in to ROUTER ISIS mode.
2. Enter the command address-family ipv6 unicast. The prompt changes to include (conf-router_isis-af_ipv6).
LLDP Mode
To enable and congure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information, refer to Link Layer Discovery
Protocol (LLDP).
To enter LLDP mode:
1. To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP on an interface, verify that
you are logged in to INTERFACE mode.
50
CLI Basics