Users Guide

The system reboots when the o-line diagnostics complete. This reboot is an automatic process. A warning
message appears when the offline stack-unit command is implemented.
Warning - Diagnostic execution will cause stack-unit to reboot after
completion of diags.
Proceed with Offline-Diags [confirm yes/no]:y
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
clear hardware stack-unit
Clear statistics from selected hardware components.
Syntax
clear hardware stack-unit id {counters | unit 0–0 counters | cpu data-plane
statistics | cpu i2c statistics | cpu party-bus statistics | cpu sata-
interface statistics | stack-port 0–127}
Parameters
stack-unit id Enter the keywords stack-unit then a number to select a particular stack
member and then enter one of the following command options to clear a specic
collection of data. The range is from 1 to 6.
counters Enter the keyword counters to clear the counters on the selected stack member.
unit number
counters
Enter the keyword unit along with a port-pipe number, then the keyword
counters to clear the counters on the selected port-pipe. The range is from 0 to 0.
cpu data-plane
statistics
Enter the keywords cpu data-plane statistics to clear the data plane
statistics.
cpu party-bus
statistics
Enter the keywords cpu party-bus statistics to clear the management
statistics.
stack-port Enter the keywords stack-port then the port number of the stacking port to
clear the statistics of the particular stacking port. The range is from 1 to 52.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
488
Debugging and Diagnostics