Users Guide

• vrfv4Acl :0
• Openow : 0
• fedgovacl : 0
l2acl number Enter the keyword l2acl and then the number of l2acl blocks. The range is from 1
to 8.
ipv4acl number Enter the keyword ipv4acl and then the number of FP blocks for IPv4. The
range is from 0 to 8.
ipv6acl number Enter the keyword ipv6acl and then the number of FP blocks for IPv6. The
range is from 0 to 4.
ipv4qos number Enter the keyword ipv4qos and then the number of FP blocks for IPv4. The
range is from 0 to 8.
l2qos number Enter the keyword l2qos and then the number of FP blocks for l2 qos. The range
is from 1to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks for l2 protocol
tunnelling. The range is from 0 to 1.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP blocks for IP and MAC
ACL. The range is from 0 to 6.
ecfmacl number Enter the keyword ecfmacacl and then the number of FP blocks for ECFM ACL.
The range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of FP blocks for
nlbcluster ACL. The range is from 0 to 2. By default the value is 0 and it supports 8
NLB arp entries reserved for internal functionality.
NOTE: When you recongure CAM allocation, use the nlbclusteracl
number command to change the number of NLB ARP entries. The range is
from 0 to 2. The default value is 0. At the default value of 0, eight NLB ARP
entries are available for use. This platform supports up to 512 CAM entries.
Select 1 to congure 256 entries. Select 2 to congure 512 entries. Even
though you can perform CAM carving to allocate the maximum number of
NLB entries, Dell Networking recommends that you use a maximum of 64
NLB ARP entries.
Vman-qos|vman-
dual-qos number
Enter the keyword evman-qos and then the number of FP blocks for VMAN QoS.
The range is from 0 to 6.
vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of FP blocks for
VMAN dual QoS. The range is from 0 to 4.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP blocks for ipv4pbr ACL.
The range is from 0 to 8.
Openow number Enter the keyword openflow and then the number of FP blocks for open ow
(multiples of 4). The range is from 0 to 8.
fcoeacl number Enter the keyword fcoeacl and then the number of FP blocks for FCOE ACL.
The range is from 0 to 6.
Iscsioptacl number Enter the keyword iscsioptacl and then the number of FP blocks for iSCSI
optimization ACL. The range is from 0 to 2.
l2acl number
ipv4acl number
Allocate space to each CAM region.
Content Addressable Memory (CAM)
469