Users Guide

NOTE: The no feature vrf command is not supported on any of the platforms.

To enable the VRF feature and cause all VRF-related commands to be available or viewable in the CLI interface, use the following

command. You must enable the VRF feature before you can congure its related attributes.

Dell(conf)# feature vrf

Based on whether VRF feature is identied as supported in the Feature Conguration le, conguration command feature vrf

becomes available for usage. This command will be stored in running-conguration and will precede all other VRF-related

congurations.

NOTE: The MXL and Z9000 platforms currently do not support VRF. These platforms support only the management and

default VRFs, which are available by default. As a result, the feature vrf command is not available for these platforms.

To display the state of Dell Networking OS features:

Dell#show feature

Example of show feature output

For a particular target where VRF is enabled, the show output is similar to the following:

Feature State

------------------------------

VRF enabled

feature vrf

Enable the VRF application on a switch. After you enable the VRF feature, you cannot deactivate it.

Syntax

feature vrf

Defaults Disabled

Command Modes CONFIGURATION

Command History

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.5(0.0) Introduced on the Z9500.

9.4(0.0) Introduced on the S4810, S4820T, S5000, and S6000.

Usage Information You can activate VRF application on a device by using the feature vrf command in CONFIGURATION

mode. The no feature vrf command is not supported on any platform.

show feature

Verify the status of software applications, such as VRF, that are activated and running on a device.

Syntax

show feature

Command Modes

EXEC

EXEC Privilege

CLI Basics