Users Guide

IPADDR:NN Enter the IP address specic extended community in the format IPADDR:NN (4-
byte IPv4 Unicast Address:2-byte community value).
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a non-transitive BGP
extended community.
Defaults none
Command Modes ROUTE MAP (cong-route-map)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series.
Usage Information
If the set community rt and soo are in the same route-map entry, the behavior denes as:
• If the rt option comes before soo, with or without the additive option, soo overrides the
communities
rt sets.
• If the rt option comes after soo, without the additive option, rt overrides the communities soo
sets.
• If the rt with the additive option comes after soo, rt adds the communities soo sets.
Related Commands set extcommunity rt — sets the extended community route origins using the route-map.
show ip bgp paths extcommunity
To display all BGP paths having extended community attributes, use this feature.
Syntax
show ip bgp paths extcommunity
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Border Gateway Protocol
459