Users Guide

show ip bgp peer-group
Allows you to view information on the BGP peers in a peer group.
Syntax
show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6 unicast]
peer-group [peer-group-name [detail | summary]]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf to view information on BGP peers in a peer
group corresponding to that VRF.
NOTE: You can use this attribute to view information on BGP peers in a
peer group that correspond to either a default or a non-default VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
view information related only to ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to view
information related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view
information related only to ipv6 unicast routes.
peer-group-name (OPTIONAL) Enter the name of a peer group to view information about that peer
group only.
detail (OPTIONAL) Enter the keyword detail to view detailed status information of the
peers in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status information of the peers
in that peer group. The output is the same as that found in the show ip bgp
summary
command.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows the
ADDPATH parameters.
8.3.7.0 Introduced on the S4810.
446
Border Gateway Protocol