Users Guide

NOTE: Enter an escape sequence (CTRL+v) prior to entering the ?
regular expression.
• [ ] = (brackets) a range of single-character patterns.
• ( ) = (parenthesis) groups a series of pattern elements to a single element.
• { } = (braces) minimum and the maximum match count.
• ^ = (caret) the beginning of the input string. If you use the caret at the
beginning of a sequence or range, it matches on everything BUT the characters
specied.
• $ = (dollar sign) the end of the output string.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp flap command shown in the following example.
Field Description
Network Displays the network ID to which the route is apping.
From Displays the IP address of the neighbor advertising the apping route.
Flaps Displays the number of times the route apped.
Duration Displays the hours:minutes:seconds since the route rst apped.
Reuse Displays the hours:minutes:seconds until the apped route is available.
Path Lists all the ASs the apping route passed through to reach the destination
network.
Example
Dell#show ip bgp flap-statistics
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
436
Border Gateway Protocol