Users Guide

standard (OPTIONAL) Enter the keyword standard to send standard community attribute.
Defaults Not congured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information To congure a COMMUNITY attribute, use the set community command in ROUTE-MAP mode.
In order that settings corresponding to the neighbor send-community command take eect, you
must execute the
clear ip bgp command immediately after you execute the neighbor send-
community command.
If you do not set any of the optional parameters (standard or extended), then both standard as well as
extended attributes are sent. If you set either the standard or extended parameter, only the attribute that is
specied is sent.
neighbor shutdown
Disable a BGP neighbor or peer group.
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address | peer-group-
name}no shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers within the peer
group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Border Gateway Protocol
407