Users Guide

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced the limit keyword on the S4810.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
After you congure a peer group as passive, assign it a subnet using the neighbor soft-
reconfiguration inbound command.
For passive eBGP limits, the Remote AS must be dierent from the AS for this neighbor.
Related Commands
neighbor soft-reconguration inbound — assigns a subnet to a dynamically congured BGP neighbor.
neighbor remote-as — assigns an indirectly connected AS to a neighbor or peer group.
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
Syntax
neighbor {ip-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ip-address | peer-group-name}
remote-as number command.
Parameters
ip-address Enter the IP address of the neighbor to enter the remote AS in its routing table.
peer-group-name Enter the name of the peer group to enter the remote AS into routing tables of all
routers within the peer group.
number Enter a number of the AS. The range is from 0 to 65535 (2 byte) or from 1 to
4294967295 (4 byte).
Defaults Not congured.
Command Modes ROUTER BGP
Border Gateway Protocol
401