Users Guide

debug ip bgp updates
Allows you to view information about BGP updates.
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group peer-group-
name] updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X |
peer-group peer-group-name] updates [in | out | prefix-list prefix-list-
name] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view BGP
updates information corresponding to that VRF.
A.B.C.D (OPTIONAL) Enter an IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group followed by the name of the peer
group.
in (OPTIONAL) Enter the keyword in to view only BGP updates received from
neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP updates sent to neighbors.
prex-list prex-list-
name
(OPTIONAL) Enter the keyword prefix-list then the name of an established
prex list. If the prex list is not congured, the default is permit (to allow all
routes).
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all routers
within the peer group.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
382
Border Gateway Protocol