Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information
If you congure the set next-hop command, its conguration takes precedence over the neighbor
next-hop-self command in the ROUTER BGP mode.
If you congure the set next-hop command with the interface’s IP address (either Loopback or
physical), the software declares the route unreachable.
Related Commands
match ip next-hop — redistributes routes that match the next-hop IP address.
set origin
To manipulate the BGP ORIGIN attribute, congure a lter.
Syntax
set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the no set origin command.
Parameters
egp Enter the keyword egp to set routes originating from outside the local AS.
igp Enter the keyword igp to set routes originating within the same AS.
incomplete Enter the keyword incomplete to set routes with incomplete routing
information.
Defaults Not congured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Access Control Lists (ACL)
273