Users Guide

To delete a value, use the no match metric [metric-value] command.
Parameters
metric-value Enter a value to match. The range is from zero (0) to 4294967295.
Defaults Not congured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other routers.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specic tag.
match origin
To match routes based on the value found in the BGP path ORIGIN attribute, congure a lter.
Syntax
match origin {egp | igp | incomplete}
To disable matching lter, use the no match origin {igp | egp | incomplete} command.
Parameters
egp Enter the keyword egp to match routes originating outside the AS.
260
Access Control Lists (ACL)