Users Guide

• For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For a port channel interface, enter the keywords port-channel then a
number.
The range is from 1 to 128.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related Commands
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other routers.
match metric — redistributes routes that match a specic metric.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specic tag.
match ip address
To match routes based on IP addresses specied in an access list, congure a lter.
Syntax
match ip address prefix-list-name
256
Access Control Lists (ACL)