Users Guide
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
in | out Identify whether ACL is applied on ingress or egress side.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series
6.1.1.0 Introduced on the E-Series.
Usage Information The ACL hit counters increment the counters for each matching rule, not just the rst matching rule.
Example
Dell#show mac accounting access-list TestMac interface gigabitethernet 1/8
in
Ingress Standard mac access-list TestMac on GigabitEthernet 1/89
Total cam count 2
seq 5 permit aa:aa:aa:aa:00:00 00:00:00:00:ff:ff count (0 packets)
seq 10 deny any count (20072594 packets)
Dell#
Standard MAC ACL Commands
When you create an access control list without any rule and then apply it to an interface, the ACL behavior reects implicit permit.
These commands congure standard MAC ACLs and support both Ingress and Egress MAC ACLs.
234
Access Control Lists (ACL)