Users Guide

7
Access Control Lists (ACL)
Access control lists (ACLs) are supported by the Dell Networking OS.
Dell Networking OS supports the following types of ACL, IP prex list, and route maps:
• Commands Common to all ACL Types
• Common IP ACL Commands
• Standard IP ACL Commands
• Extended IP ACL Commands
• Common MAC Access List Commands
• Standard MAC ACL Commands
• Extended MAC ACL Commands
• IP Prex List Commands
• Route Map Commands
• AS-Path Commands
• IP Community List Commands
NOTE: For ACL commands that use the Trace function, refer to the Trace List Commands section in the Security
chapter.
NOTE: For IPv6 ACL commands, refer to IPv6 Access Control Lists (IPv6 ACLs).
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specic options. Some commands in this
chapter may use similar names, but require dierent options to support the dierent ACL types (for example, the deny and permit
commands).
remark
Enter a description for an ACL entry.
Syntax
remark [remark-number] [description]
Parameters
remark-number Enter the remark number. The range is from 0 to 4294967290.
NOTE: You can use the same sequence number for the remark and an ACL
rule.
description Enter a description of up to 80 characters.
Defaults Not congured.
Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
Access Control Lists (ACL)
195