Users Guide

To disable dot1x on an interface, use the no dot1x authentication command.

Defaults Disabled

Command Modes INTERFACE

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

7.6.1.0 Introduced on the C-Series and S-Series.

7.4.1.0 Introduced on the E-Series.

Related Commands dot1x authentication (Conguration) — Enables dot1x globally.

dot1x guest-vlan

Congure a guest VLAN for limited access users or for devices that are not 802.1X capable.

Syntax

dot1x guest-vlan vlan-id

To disable the guest VLAN, use the no dot1x guest-vlan vlan-id command.

Parameters

vlan-id Enter the VLAN Identier. The range is from 1 to 4094.

Defaults Not congured.

Command Modes CONFIGURATION (conf-if-interface-slot/port)